Drysuit Wrist Seal ReplacementDrysuit Wrist Seal Replacement
If you are in need of a drysuit wrist seal replacement, the following instructions will show you how to do it. Start by taking off your gloves and wearing a pair of rubber gloves. Make sure that your hands are warm and that you are positioned in a position where you can comfortably grip the jig. Next, insert the jig into the wrist seal and rotate it until it fits properly. When removing the old wrist-seal, be very careful to avoid getting burnt while working.
The Secret Of Drysuit Wrist Seal Replacement
After pulling the seal from your drysuit, insert it into the neck opening. It may not be perfectly circular when you first pull it out, but it will be the same width all the way around. The neck seal comes with a paper coating that is easy to peel off. Line up the new one so that about an eighth of an inch of adhesive shows on the back. Then, place the replacement into the dry suit and apply heat and pressure to it for 30 seconds.
Once you have removed the old seal, insert the new one. Make sure the new seal is lined up with the seam. If it’s not, pull it through until the surface of the suit is flush with the edge of the seal. After this, pull it all the way through the suit and apply pressure to it. Once you’ve finished installing the seal, you’re ready for the first set of heat and pressure. If you’re in need of a drysuit wrist seal replacement, it may be a good idea to take it to a specialist for assistance.